Solus wrote on Oct 26^th, 2018 at 3:15pm:

I have the "half hinge attachment" on the yoke I referenced earlier. I leave the pins and hinge attached and simply use the flex of the hull to slide the wooden yoke into place.

I like that set-up for a fixed removable yoke Solus.
I also think you could take a regular wooden yoke, set it where you want it and cut for a snug fit using the hull flex as you did.

The DIY part comes into NOT putting 2 bolts thru each side but a SINGLE clevis pin with a washer top and bottom and a clip like you used. Maybe wire the clip to the clevis pin so you don't lose parts? They also make clips with a wire hook to keep the pin secure.

The make ADJUSTABLE clevis pins, you just get one longer than you need and use stainless washers to make the fit tight when you put the clip on.

Something like this? You could make a few positions to account for gear weight once you have a system you like.

  (You need to Login or Register